Material of 110mm PECD Cutter
For 110mm corrugated upper sheath removal.
Steel Corrugated ring
Instructions: Striping Outer duct
1- Put the cutter into the outer duct
2- Pill off the skin of COD spinning right
3- Cutting Skin of COD and remove COD
cutter spinning left
4- Trimming Sub-duct and complete
5- To clamp and secure both ends of the
6- Insert Couplings in each sub duct
clamped beside the tool’s lever arm.
7- Operate the lever arm of the Jointing Tool
to move the duct towards the opposite
8- Guide the Sub duct Couplings until they
mate with the opposite sub-ducts.
9- To close and cover the joint. One part
below the joint, covering 2 grooves of the
duct and the other part to mate with the
10- Tighten the bolts of the closure. The
completed PECD jointing.